Packing MethodUser Guide

Stacking

Stacking fills nested columns of parts, upright or on their side, then tiles them across the box. Built for tubes, sleeves, cans and stamped sheet metal.

Best for Tubes, sleeves, cans and sheet metal that nest along one axis.

Stacking: nested columns of parts tiled across a box

Stamped parts such as trays, brackets and panels are mostly empty space inside their bounding boxes, but they nest. Stacking takes advantage of that. It fills a single nested column with as many parts as fit, upright or on its side, then tiles that column across the box.

How it works

Release 1.10 rebuilt the column builder from the ground up. Stacks can run vertically up the box or horizontally across the floor, and the engine adjusts part orientation automatically to find the densest stack. Stacking works with partitions, layer dividers and molded trays.

Settings

  • Stacking direction: vertical or horizontal.
  • Maximum tilt angle: 0 to 45 degrees.
  • Spacing: between parts, between stacks and between layers.
  • Maximum parts per stack: caps a column for handling or weight.
  • Layers: tier stacks into layers with separators.

In the published studies

Case Container Parts per container Cost per part
Steel bracket 12 × 12 × 8 in carton 14 to 23 (1.6×) $0.081 to $0.054, 33% lower
Car door panel 52 × 48 × 58 in returnable rack 75 to 134 (1.8×) $0.577 to $0.348, 40% lower

The door panel result also shrank the returnable rack fleet from 59 racks to 33. The parts, containers and freight stayed the same; only the stacking decision changed.

When to use it

  • Tubes, sleeves and cans.
  • Stamped sheet metal, trays and panels that nest along one axis.
  • Returnable racks where a denser stack shrinks the fleet.

Questions about Stacking

Can stacks run horizontally?

Yes. Since release 1.10, stacks can run vertically up the box or horizontally across the floor.

How much can Stacking save on stamped parts?

In the published study, Stacking cut cost per part by 33% for a steel bracket and 40% for a car door panel, with the same containers and freight.

Articles on Stacking

  • The same bent stamped part in the same carton: manual orientation at $0.08 per part versus Pack Studio's stacking orientation at $0.05 per part

    TechnicalAugust 17, 2026

    Stacking: Minimizing the Shipping Cost for Stamped Parts

    Stamped parts waste space in compartments but nest well. Pack Studio's Stacking mode builds tight nested columns and cuts cost per part 33% to 40%.

    Qiaodong Cui5 min read

  • Two tray types in Pack Studio 1.10: die-cut foam, and thermoformed plastic molded to the part contours

    Software Release NotesJuly 6, 2026

    Pack Studio 1.10 Software Release Notes

    Pack Studio 1.10 rebuilds Stacking, sizes boxes for you, adds Optimal orientation, two tray types, dunnage CAD export, wooden crates and an in-app User Guide.

    Jack Bernatchez3 min read

Sources for the figures on this page

  1. Stacking: Minimizing the Shipping Cost for Stamped Parts, Pack Studio, 2026-08-17. Cost per part, Stacking versus Flexible Layering: 33% lower; Cost per part, Horizontal Stacking versus the unstacked baseline in a returnable rack: 40% lower.

Every figure resolves from the facts registry.

Machine viewWhat agents read

Loading…