Packing MethodUser Guide

Flexible Layering

Flexible Layering builds a 3D lattice so parts interlock in every direction. Highest fill on awkward shapes, with a less uniform stack and more compute time.

Best for Irregular, nestable parts where fill rate matters more than a uniform stack.

Flexible layering: parts interleaving across three dimensions in one lattice

Flexible Layering builds a three-dimensional lattice. Instead of sitting in separable flat layers, parts interlock in every direction. It reaches the highest fill on awkward shapes, at the cost of a less uniform stack and more compute time.

How it works

Pack Studio searches a lattice of positions and rotations so copies of the part interleave across all three axes. Every candidate lattice is costed with the same engine as a full analysis, so the option that ranks first is the one with the lowest cost per part, not just the densest geometry.

When to use it

  • Irregular, organic or nestable parts that waste space in a grid.
  • Lanes where freight dominates and every extra part per truck counts.
  • Packs unloaded by automation or dumped, where a uniform stack matters less.

Settings

Compared with Stacking

For stamped parts that nest along one axis, Stacking can beat Flexible Layering. In the published stamped bracket study, Stacking fit 23 parts per carton against 14, for 33% lower cost per part. Run both and let the cost ranking decide.

Questions about Flexible Layering

What is the tradeoff with Flexible Layering?

It reaches the highest fill on awkward shapes, but the stack is less uniform than Planar Layering and the search takes more compute time.

Articles on Flexible Layering

Sources for the figures on this page

  1. Stacking: Minimizing the Shipping Cost for Stamped Parts, Pack Studio, 2026-08-17. Cost per part, Stacking versus Flexible Layering: 33% lower.

Every figure resolves from the facts registry.

Machine viewWhat agents read

Loading…