IndustriesIndustrial Parts and Fasteners

Packaging Optimization for Industrial Parts and Fasteners

Small parts. Big freight bills.

Fasteners, clips, castings and machined parts ship in huge volumes, so a few more parts per tote or a lighter board grade repeats on every shipment. Pack Studio counts, packs and costs them from CAD.

Where packaging cost hides.

  • Bulk counts are guesses: totes are filled by volume and a fill factor, not by the actual part geometry.
  • High mix: hundreds of part numbers, each needing its own pack, container and count.
  • Finished surfaces: machined and plated parts scuff in transit and need protection that is priced in.
  • Weight-limited freight: on dense steel parts, the truck's weight limit often decides the pack.

Built for parts that ship by the thousand

Industrial manufacturers and distributors ship small, dense and often identical parts in very high volumes. The packaging decisions look minor, a tote size here, a board grade there, but they repeat on every shipment for years.

Pack Studio handles the full range in one tool: loose parts poured into totes with Bulk packing, finished parts protected with Compartment cells and Partitions, and cartons sized with Optimize Box. Every option is ranked on cost per part with the truck's cube or weight limit included, which matters for dense steel parts.

The published evidence

Two of Pack Studio's published studies use industrial parts. A stamped steel bracket shipped at 33% lower cost per part with Stacking, and a steel pipe connector shipped at 15% lower cost per part with Optimal orientation. The same tests can run on your parts.

Where Pack Studio fits.

Industrial Parts and Fasteners questions.

Can Pack Studio count loose parts in a tote?

Yes. Bulk packing simulates parts poured into the container and settling under gravity and friction, then counts and costs the result.

What if a part has no CAD yet?

The Part Designer describes it as a box, sphere or cylinder, so a pack can be estimated before CAD exists.

Bring a part from your line.

We run it live and rank every option on landed cost.

Sources for the figures on this page

  1. Stacking: Minimizing the Shipping Cost for Stamped Parts, Pack Studio, 2026-08-17. Cost per part, Stacking versus Flexible Layering: 33% lower.
  2. Optimal Orientation: Packing Complex Parts at the Best Angle, Pack Studio, 2026-08-07. Cost per part, Optimal orientation versus best of six hand-picked orientations: 15% lower.

Every figure resolves from the facts registry.

Machine viewWhat agents read

Loading…