The obvious pose leaves parts on the table
For a simple box-shaped part, orientation is easy. For a casting, a connector or a molded figure, the densest pose is almost never the one that looks natural, and testing rotations by hand is slow enough that most teams stop after two or three.
What Pack Studio does
Pack Studio proposes three kinds of pose and ranks every one on cost:
- Stable: the ways a part rests on a flat surface without tipping.
- Minimal: the axes of the tightest bounding box.
- Optimal: the engine searches all 3D rotations for the densest lattice, with copies allowed to interlock when Horizontal Nesting is on.
Each candidate is costed with the same engine as a full analysis, so the winner is the least expensive to ship. The search runs on Pack Studio's own packing engine, Scalable Spectral Packing (SSP), published at SIGGRAPH 2023. Read how it finds the best orientation.
What it changes
In the published study, with the same carton, pallet, truck and freight, the Optimal pose fit about 20% more parts per carton and left cost per part 23% lower for a plastic figurine and 15% lower for a steel pipe connector.
Who uses it
Engineers packing complex, organic or awkward parts, where hand-picked orientations leave density behind.
See it work
Questions about Part Orientation
Can I still choose the orientation myself?
Yes. Add custom angles alongside the stable, minimal and Optimal poses. Every pose is packed and ranked separately.
Which packing methods support Optimal orientation?
Planar Layering and Flexible Layering. Stacking adjusts orientation automatically.


