Stamped parts ship a lot of air
Brackets, trays and panels are mostly empty space inside their bounding boxes. Packed one by one, they fill a box with air. Packed in nested columns, the same parts take a fraction of the volume. The hard part is working out the column, the tilt and the tiling for every part on a program.
What Pack Studio does
Stacking builds a single nested column with as many parts as fit, upright or on its side, then tiles that column across the container. Release 1.10 rebuilt the column builder from the ground up: stacks run vertically or horizontally, orientation adjusts automatically, and you can cap parts per stack for handling or weight. Stacks work with partitions, layer dividers and molded trays, and every option is costed on box, dunnage, pallet and freight.
What it changes
| Case | Container | Parts per container | Cost per part |
|---|---|---|---|
| Steel bracket | 12 × 12 × 8 in carton | 14 to 23 | 33% lower |
| Car door panel | 52 × 48 × 58 in returnable rack | 75 to 134 | 40% lower |
The door panel result also cut the returnable rack fleet from 59 racks to 33. The parts, containers and freight stayed the same. Only the stacking decision changed.
Who uses it
Automotive and industrial packaging teams with stamped content, and any program where returnable racks are a capital decision made early with little data. See Returnable Assets for fleet sizing and payback.
See it work
Questions about Stacking
Which parts are right for Stacking?
Parts that nest along one axis: stamped trays, brackets and panels, tubes, sleeves and cans. If a part is mostly empty space inside its bounding box but copies slide into each other, Stacking is worth a run.
Can Stacking shrink a returnable fleet?
Yes. A denser rack means fewer racks for the same volume. In the published door panel study, Horizontal Stacking cut the fleet from 59 racks to 33.


