Packing MethodUser Guide

Planar Layering

Planar Layering builds a box one flat layer at a time, each layer a grid stacked to the ceiling. Predictable, easy to unload by hand and simple to audit.

Best for Parts with a stable flat face that are picked layer by layer.

Planar layering: a grid of parts per layer stacked floor to ceiling

Planar Layering builds the pack one flat layer at a time. Each layer is a grid of parts, and layers stack from the floor of the container to the ceiling. The result is predictable, easy to unload by hand and simple to audit, which is why it is the default choice for parts with a stable flat face.

How it works

Pack Studio lays out a grid for the first layer, repeats it up the box and stops at the height limit set by the container, your margins and any weight cap. Layer separators, such as a corrugated C-flute pad between every layer, are added to the pack and to its cost.

With Horizontal Nesting turned on, neighboring parts in a layer can tuck into each other's concave features. That is how a thin-walled funnel that fills only about 7% of its bounding cube still packs densely: in the published box sizing study, Planar Layering with Horizontal Nesting fit 1,245 funnels in an optimized tray against 768 in the best stock carton.

When to use it

  • Parts with a flat, stable face that sit the same way in every layer.
  • Lines that pick by hand, one layer at a time.
  • Packs that quality teams need to count or inspect quickly.
  • Grid layouts that pair with partitions so parts never touch.

Settings

  • Part orientation: stable, minimal or Optimal poses. See Part Orientation.
  • Horizontal Nesting: lets parts interlock within a layer.
  • Margins and layer separators: clearance around each part and pads between layers.

In the published studies

The Optimal orientation study used Planar Layering in a regular slotted container (RSC) 12 × 12 × 8 in carton with Horizontal Nesting on. Searching 3D rotations cut cost per part by 23% lower for a plastic figurine and 15% lower for a steel pipe connector.

Questions about Planar Layering

When should I choose Planar Layering over Flexible Layering?

Choose Planar Layering when operators unload by hand, layer by layer, or when the pack must be easy to audit. Choose Flexible Layering when fill rate matters more than a uniform stack.

Does Planar Layering work with Optimal orientation?

Yes. Optimal orientation is a Part Orientation setting on both Planar Layering and Flexible Layering.

Articles on Planar Layering

Sources for the figures on this page

  1. Optimal Orientation: Packing Complex Parts at the Best Angle, Pack Studio, 2026-08-07. Cost per part, Optimal orientation versus best hand-picked orientation: 23% lower; Cost per part, Optimal orientation versus best of six hand-picked orientations: 15% lower.

Every figure resolves from the facts registry.

Machine viewWhat agents read

Loading…