The problem with grids
A grid treats every part like a box. For a bracket, a casting or a molded part with arms and pockets, most of that box is air, and air is what you pay to ship. Teams know denser arrangements exist, but finding one by hand means hours of trial in CAD for a single part.
What Pack Studio does
Flexible Layering searches a lattice of positions and rotations so copies of the part interleave in all three directions. Each candidate lattice is costed with the same engine as a full analysis, including protective packaging, pallet and freight, so the winner is the least expensive to ship rather than the most impressive geometry.
It works with Optimal orientation, which searches 3D rotations for the densest pose, and with Nesting and Repacking, which fills the space a lattice leaves behind.
Know when to use something else
Density is not the only goal. For stamped parts that nest along one axis, Stacking often wins: in Pack Studio's published bracket study, Stacking fit 23 parts per carton against 14 with Flexible Layering, for 33% lower cost per part. Because both run in the same tool, you do not have to guess. Run both and let the cost ranking decide.
Who uses it
Engineers packing irregular parts on high-volume lanes, where freight dominates the cost and the pack is unloaded by automation or dumped rather than picked layer by layer.
See it work
Questions about Flexible Layering
When does Flexible Layering beat Planar Layering?
When parts are irregular or nestable and every extra part per truck matters more than a uniform, hand-picked stack. Packs that are dumped or unloaded by automation are good candidates.
Does Flexible Layering take longer to compute?
Yes. Searching a full 3D lattice takes more compute time than a flat grid. Results still arrive as ranked options, so you can compare it with faster methods in the same run.


