Why the obvious pose is usually wrong
People orient parts by intuition: flat face down, long axis along the box. For box-shaped parts that works. For complex, organic or awkward parts, the densest arrangement often uses a tilted pose that lets copies interleave. There are infinitely many rotations, and testing even a handful by hand in CAD takes hours.
Three kinds of pose worth testing
- Stable poses: the ways the part rests on a flat surface without tipping. Practical for hand packing.
- Minimal poses: the axes of the part's tightest bounding box. A quick baseline.
- Optimal pose: found by searching rotations for the densest lattice of copies.
How the search works
Pack Studio's engine, Scalable Spectral Packing (SSP), represents parts and containers as voxel grids and uses the fast Fourier transform (FFT) to score collisions and gaps for every candidate position at once. That is what makes searching many rotations fast enough to run on every part. The paper behind it, published in ACM Transactions on Graphics, SIGGRAPH 2023, reports placing 670 objects in 40 seconds.
Every candidate pose is then costed with the full model, box, protective packaging, pallet and freight, so the pose that wins is the least expensive to ship, not just the densest.
What it changes
In Pack Studio's published study, with the same carton, pallet, truck and freight, the Optimal pose left cost per part 23% lower for a plastic figurine and 15% lower for a steel pipe connector.
Try it
Part Orientation runs inside every analysis. Bring the part you think is already optimized, or send it to us.