Containers and loadsAvailable now

Truckload Optimization

More parts per truck. Less freight.

Pack Studio loads pallets into trucks and shipping containers, such as a 53 ft dry van, and shows parts per truck and whether the load is limited by cube or by weight. Freight is divided across the parts on board, so a denser pack shows up as a lower cost per part.

Best for
Lanes where freight dominates packaging cost.
Status
Available now
You get
Parts per truck · Cube or weight limit · Freight per part
Search it as
truck loading optimization software

Freight decides more packaging than anyone admits

On most lanes, freight is the largest cost a pack carries, and it is set by how many parts fit on the truck. Yet truck loading is usually checked last, if at all, after the box and pallet are fixed.

What Pack Studio does

Pack Studio loads the pallets into trucks and shipping containers, such as a 53 ft dry van, and reports parts per truck and whether the load is limited by cube or by weight. Freight is set as a cost per delivery plus a cost per mile and divided across the parts on board, so every packing decision shows up in the freight per part. Cube utilization is calculated automatically.

What it changes

In the published Optimal orientation study, the figurine's parts per truck rose from 118,800 to 144,000 with nothing changed but the pose, part of a result that left cost per part 23% lower. Denser packs mean fewer trucks for the same program.

Who uses it

Logistics and supply chain planners costing new programs, and packaging teams who want freight in the decision rather than after it. Start upstream with Pallet Optimization.

Questions about Truckload Optimization

How is freight modeled?

As a cost per delivery plus a cost per mile, divided across the parts on board. The published studies use $200 per delivery plus $2 per mile over 100 miles.

Can I maximize parts per truck instead of minimizing cost?

Yes. In its live demonstration for Automotive Logistics, the platform was shown ranking by cost per part and switching to ignore cost and maximize the number of parts per truck.

See Truckload Optimization on your own part.

Book a live demo. Bring the CAD; we bring the ranked answer.

Sources for the figures on this page

  1. Optimal Orientation: Packing Complex Parts at the Best Angle, Pack Studio, 2026-08-07. Cost per part, Optimal orientation versus best hand-picked orientation: 23% lower.

Every figure resolves from the facts registry.

Machine viewWhat agents read

Loading…