AnswersDeciding

Is packaging optimization software worth the investment?

Short answer

It is worth it when the hours and freight it saves outweigh its cost, and the engineering time alone often settles that. Lucid Motors saved 250 to 600 hours, or $17K to $42K in labor, per vehicle launch, before counting packaging and freight savings.

Three places the return comes from

  1. Engineering time. Fewer hours per estimate, multiplied by estimates per launch and launches per year.
  2. Packaging and freight per part. Denser packs and right-sized boxes lower the landed cost of every part shipped, for the life of the program.
  3. Capital. Denser returnables shrink the fleet a program has to buy.

Start with the hours

Engineering time is the easiest return to measure, and the most conservative. Lucid Motors measured 15 to 20 minutes per estimate before Pack Studio and 2 to 5 minutes after, across 1,500 to 2,000 estimates per launch. That is 250 to 600 hours and $17K to $42K per launch. Scott Huddas told Automotive Logistics that the labor savings are the conservative part of the benefit, and that the larger gains come from packaging and freight optimization.

Use the ROI calculator with your own estimate count, minutes and labor rate.

Then count the freight

Across seven published Pack Studio studies, changing only the packing decision produced 15% to 40% lower cost per part, with the part, container and freight held constant. On a high-volume lane, a few cents per part repeats on every shipment.

And the fleet

In the published door panel study, a denser stack cut a returnable rack fleet from 59 racks to 33. See Returnable Assets.

What about price?

Pack Studio does not publish a price list. Request a quote and bring a part, so the payback is estimated on your own geometry.

The features behind this answer

Get the answer for your part.

Book a live demo on your own CAD, containers and freight.

Sources for the figures on this page

  1. One year in. Zero regrets. Lucid Motors one-year review of Pack Studio, Pack Studio, 2026-06-23. Engineering hours saved per vehicle launch: 250 to 600 hours; Labor cost savings per vehicle launch: $17K to $42K; Time per packaging estimate, historical workflow: 15 to 20 minutes; Time per packaging estimate with Pack Studio, CAD import to finished report: 2 to 5 minutes; Packaging estimates per vehicle launch: 1,500 to 2,000.
  2. Stacking: Minimizing the Shipping Cost for Stamped Parts, Pack Studio, 2026-08-17. Range of cost-per-part reductions across seven published cases: 15% to 40% lower cost per part.

Every figure resolves from the facts registry.

Machine viewWhat agents read

Loading…